top of page
Digital Creation
Wedge of the Backpack
I had to 3d print the wedge for the backpack. I had help from a classmate in class because I did not have much experience in 3d printing. These two prints took about 23 hours to finish printing. This helped as a balancer for the wheels of the backpack. 3d printing was the best option for making a balanced bottom of the backpack.
POLE CONNECTOR
This pole connect was used to connect the poles of the tent so that it is sturdy. This pole connector consist of 3 holes that makes the poles fit perfectly inside the connector.
Measurement
The measurements for the pole connect is:
.336 inches in diameters
.272 inches inside
To get the measurement I needed I had to measure the tent poles I was using for the tent. I used a caliper to measure these diameters.
bottom of page